Today was not as good a day as yesterday getting the fixings out of the portside covering boards

Getting the fixings out of the rest of the portside deck edge covering boards as been a long drawn out job. As many of the fixings are cross head or otherwise known as Phillip head screws. 


These screws are often screwed in with power screwdrivers and in the process run out the heads so you can not remove the screw out of the hole or the head is full of glue from when the hardwood plug was fitted over the screw head.


You can see in the photo that the head is full of glue and the edges of the screw driver head are run off


The power these screws were drien in they even bend the head ove on some of the ones I was able to remove.


Fast to drive the screw in and almost impossible to remove when they are in this condition 


 

Comments

Post a Comment

Popular posts from this blog

Cleaning up the portside propeller Shaft & the propeller to find out the diameter and pitch & the manufacturer of the propeller

Image
Chance like a lot of James Silver / John Bain designed boats at the time Chance was build, they were twin screw single rudder designed.  The stern gear glands were of white metal and were very close fitting glands The original propellers that were fitted when Chance was originally launched in 1948 The original manufacturer of the propeller can be seen as Thornycroft   On this photo is can be seen that the diameter is 17 1/2 " x 12 1/2" These propeller shafts will have to be removed as there is work to be done on the stern tubes and the bearing changed to modern stern gear when Chance is re-engineered   
Read more

Engine filters from 70 years ago, all the parts can be washed and refitted non disposable parts, so no land fill

Image
The good part about the old fuel filter system on Chance is that it is a non disposable system, so it just needs cleaning at regular intervals to keep it working  Although there are a number of parts to the filter system it is straightforward and easy to dismantle and rebuild when it needs cleaning to maintain the engines   Just need a couple of parts replacing as they are worn out, apart from that the system is ready to be reused again for another 70 years or more   
Read more

A year to remember and also forget.

 This past year as been one of many turns and changes along the way. We had plans to get the restoration of Chance underway in a major way. however this was not to be the case. As the following paragraph will show you. Having moved Chance from Woodplumpton in the previous November to Walton on the Naze in Essex, we set about making plans to start doing the restoration in the spring of this year.  However, this was derailed by the passing of my wife's mother after a long illness, this event happened and so the project was put on hold for most of the year apart from doing the odd bit here and there either on Chance or in the workshop doing small jobs while we rebuild our lives once more,  So has the months when on during 2023 without the heart to move the project along the project ground to a slow halt and in the end it stop with a cover being put over the boat and all work stopped on the boat itself.  So we both when about our daily working lives while we came to term...
Read more