The skylights are now covered just a few more holes to fill in around the boat

The skylights are now covered with plywood while we work on the rest of the boat. The skylight hatches are now varnished and in storage until it is time for them to go back on once the base part as been restored to its original condition and varnished again.


The sliding doors will have to be removed and repaired as necessary and new glass made and fitted once more. There is also some work to be done on the wheelhouse side where it as been damaged and not repaired very well in the past. 


The aft cabin hatch top section as been repaired however, the bottom part needs a bit of TLC and rubbing down re-varnishing 




 

Comments

Post a Comment

Popular posts from this blog

Cleaning up the portside propeller Shaft & the propeller to find out the diameter and pitch & the manufacturer of the propeller

Image
Chance like a lot of James Silver / John Bain designed boats at the time Chance was build, they were twin screw single rudder designed.  The stern gear glands were of white metal and were very close fitting glands The original propellers that were fitted when Chance was originally launched in 1948 The original manufacturer of the propeller can be seen as Thornycroft   On this photo is can be seen that the diameter is 17 1/2 " x 12 1/2" These propeller shafts will have to be removed as there is work to be done on the stern tubes and the bearing changed to modern stern gear when Chance is re-engineered   
Read more

Engine filters from 70 years ago, all the parts can be washed and refitted non disposable parts, so no land fill

Image
The good part about the old fuel filter system on Chance is that it is a non disposable system, so it just needs cleaning at regular intervals to keep it working  Although there are a number of parts to the filter system it is straightforward and easy to dismantle and rebuild when it needs cleaning to maintain the engines   Just need a couple of parts replacing as they are worn out, apart from that the system is ready to be reused again for another 70 years or more   
Read more

What to say in videos which interest people to watch my video's

Show less Over the past three or so years, We as a family have tried to document the restoration of Chance. The restoration project as taken a long time as it as been done during the Covid 19 pandemic and the fact Chance was in a different part of the country to where we live, in Woodplumpton in Lancashire and we live in North East Essex, so the trips to Chance for the first two years of her restoration have been a long distance affair to say the least. However, we were up to it and we did a lot of work removing much of the old furniture and the other items from inside Chance which were beyond saving, such as rusted fuel and water tanks, worn out stern gear, Seized engines which could not be restored without a lot of money being spend on them. The inside of Chance was photographed a lot so to keep a record of how much of the interior was intact and what had been changed over the years and not always for the better and in some case caused major problem to the hull structure. this was fo...
Read more