Sorting out more doors and hatches, Chance as quiet a few and they all need varnishing

While looking on the workshop shelf I was able to find the main cabin door that had been varnished in the past before being put away until now. It will a dusting down and a light sanding and it can be put with the rest of the doors and cabinetry to be varnished before being refitted to the boat as we rebuild the inside of the boat. 


These two panels are the lifting parts from the main entrance to the main cabin from the cockpit. 


The starboard side galley front being given a sealing coat of varnish while we sort out how to fill in the two holes on the top right hand side part of the galley front.


The port side galley corner panels now getting a sealing coat of varnish, before we start to refit the port side galley unit back together in te boat.


These two door are from the main cabin starboard side sideboard, the framework was in a bit of a poor condition so we are having to rebuild the framework to fit these door back on to when we refit the starboard sideboard in the main cabin after we have done all the work on the hull.


 

Comments

Post a Comment

Popular posts from this blog

Cleaning up the portside propeller Shaft & the propeller to find out the diameter and pitch & the manufacturer of the propeller

Image
Chance like a lot of James Silver / John Bain designed boats at the time Chance was build, they were twin screw single rudder designed.  The stern gear glands were of white metal and were very close fitting glands The original propellers that were fitted when Chance was originally launched in 1948 The original manufacturer of the propeller can be seen as Thornycroft   On this photo is can be seen that the diameter is 17 1/2 " x 12 1/2" These propeller shafts will have to be removed as there is work to be done on the stern tubes and the bearing changed to modern stern gear when Chance is re-engineered   
Read more

A big shout out for a cover to put over Chance so we can get on with the restoration of Chance.

Image
 At the moment we are in this position with Chance, We have a large poly sheet over Chance which keeps getting blown off as we can not fix it down very well and is a thankless task having to keep pulling over the boat until the next major gale of strong wind decides to remove the cover again.  That's the position at the moment, what we are looking for is a shed/workshop like the one over Helen Wycherley Heritage Restoration project in Whitby North Yorkshire. This type of shed/ workshop would do our restoration project a world of good and make possible for us to get on with our restoration of Chance.    So if anyone out there can put us in contact with anyone who wishes to move on their poly tunnel shed/ workshop, please get in contact with us through our social media channels. This would help our restoration project get underway again. Te cost of building a new shed is way out of our price range and without some help it is looking in a grave way as to how to move for...
Read more

Chance Autumn update

As many of you will have seen from the lack of updates there as been little work done on Chance over the summer. This as been due a lack of time and more over a lack of funds to do major task done on Chance. especially the removal of the middle and aft section of the starboard beam shelf and reconstructing the transom and its framework which holds it in position.   However, all is not doom and gloom, has I have been able to take on an apprentice to help me during the working week on my clients boats and leave myself and wife time to get on with working on Chances repairs.  So hopefully over the coming week's we should be able to make a start on getting the beam shelf removed and replaced with a new correctly fitted beam shelf which will bring the hull back into position  along with the ribs and frames which have to be replaced at the same time to get the hull back into its correct position once more.  There is going to be a lot of shoring up of the starboard sid...
Read more