Gluing the new pieces on the ends of the Galley fronts which needed replacing

After we removed the old rotten ends of the two pieces that were affected it was time to cut the ends and glue new pieces on the ends.


Thankfully the amount of rotten wood was small and just two small pieces of Mahogany were needed to be found from the pile of old mahogany which was of the similar age to the original mahogany used in the construction of the galley front.


Clamping in two directions will help keep the new pieces in the correct position while the glue cures and we are able to remove the clamps and plane and sand the new pieces to match the original parts.



These two holes are going to be interesting to cover. A diamond shaped grating piece over the two holes and then a good planing and sanding an a small amount of mahogany staining and this will be as good as new. 


 

Comments

Post a Comment

Popular posts from this blog

Cleaning up the portside propeller Shaft & the propeller to find out the diameter and pitch & the manufacturer of the propeller

Image
Chance like a lot of James Silver / John Bain designed boats at the time Chance was build, they were twin screw single rudder designed.  The stern gear glands were of white metal and were very close fitting glands The original propellers that were fitted when Chance was originally launched in 1948 The original manufacturer of the propeller can be seen as Thornycroft   On this photo is can be seen that the diameter is 17 1/2 " x 12 1/2" These propeller shafts will have to be removed as there is work to be done on the stern tubes and the bearing changed to modern stern gear when Chance is re-engineered   
Read more

Engine filters from 70 years ago, all the parts can be washed and refitted non disposable parts, so no land fill

Image
The good part about the old fuel filter system on Chance is that it is a non disposable system, so it just needs cleaning at regular intervals to keep it working  Although there are a number of parts to the filter system it is straightforward and easy to dismantle and rebuild when it needs cleaning to maintain the engines   Just need a couple of parts replacing as they are worn out, apart from that the system is ready to be reused again for another 70 years or more   
Read more

A big shout out for a cover to put over Chance so we can get on with the restoration of Chance.

Image
 At the moment we are in this position with Chance, We have a large poly sheet over Chance which keeps getting blown off as we can not fix it down very well and is a thankless task having to keep pulling over the boat until the next major gale of strong wind decides to remove the cover again.  That's the position at the moment, what we are looking for is a shed/workshop like the one over Helen Wycherley Heritage Restoration project in Whitby North Yorkshire. This type of shed/ workshop would do our restoration project a world of good and make possible for us to get on with our restoration of Chance.    So if anyone out there can put us in contact with anyone who wishes to move on their poly tunnel shed/ workshop, please get in contact with us through our social media channels. This would help our restoration project get underway again. Te cost of building a new shed is way out of our price range and without some help it is looking in a grave way as to how to move for...
Read more