After the water & Fuel tank were removed it was time to clean out the engine bay out of all the old rubbish and dirt

Now that tanks are out it is possible to remove all the old tank support bracket and clean the years of dirt that had collected in the engine bay 





The first time oin over 70 years the bottom of the bilge in the engine bay as seen the light of day and it is good order after all the neglect it as had over the 20 plus years until we came to Chance rescue  




All that is needed now is the old bilge ump and water pipes to be removed and then the cleaning can start






 

Comments

Post a Comment

Popular posts from this blog

Cleaning up the portside propeller Shaft & the propeller to find out the diameter and pitch & the manufacturer of the propeller

Image
Chance like a lot of James Silver / John Bain designed boats at the time Chance was build, they were twin screw single rudder designed.  The stern gear glands were of white metal and were very close fitting glands The original propellers that were fitted when Chance was originally launched in 1948 The original manufacturer of the propeller can be seen as Thornycroft   On this photo is can be seen that the diameter is 17 1/2 " x 12 1/2" These propeller shafts will have to be removed as there is work to be done on the stern tubes and the bearing changed to modern stern gear when Chance is re-engineered   
Read more

A big shout out for a cover to put over Chance so we can get on with the restoration of Chance.

Image
 At the moment we are in this position with Chance, We have a large poly sheet over Chance which keeps getting blown off as we can not fix it down very well and is a thankless task having to keep pulling over the boat until the next major gale of strong wind decides to remove the cover again.  That's the position at the moment, what we are looking for is a shed/workshop like the one over Helen Wycherley Heritage Restoration project in Whitby North Yorkshire. This type of shed/ workshop would do our restoration project a world of good and make possible for us to get on with our restoration of Chance.    So if anyone out there can put us in contact with anyone who wishes to move on their poly tunnel shed/ workshop, please get in contact with us through our social media channels. This would help our restoration project get underway again. Te cost of building a new shed is way out of our price range and without some help it is looking in a grave way as to how to move for...
Read more

Chance Autumn update

As many of you will have seen from the lack of updates there as been little work done on Chance over the summer. This as been due a lack of time and more over a lack of funds to do major task done on Chance. especially the removal of the middle and aft section of the starboard beam shelf and reconstructing the transom and its framework which holds it in position.   However, all is not doom and gloom, has I have been able to take on an apprentice to help me during the working week on my clients boats and leave myself and wife time to get on with working on Chances repairs.  So hopefully over the coming week's we should be able to make a start on getting the beam shelf removed and replaced with a new correctly fitted beam shelf which will bring the hull back into position  along with the ribs and frames which have to be replaced at the same time to get the hull back into its correct position once more.  There is going to be a lot of shoring up of the starboard sid...
Read more