Making a start on the cupboard, locker and cabin doors and then the drawers some of which some repairs doing to them

The stack of doors to work through, a lot of scraping and sanding until we get back to the original colour of the Mahogany and then a lot of varnishing


This about half of the panels that are taken off the boat, the rest are still at the boat ready for collection next time I am up at the boat to bring back to the workshop 



The doors come in a lot of different shapes and sizes 



A couple of the drawers which are in need of a lot of TLC and in some cases rebuilding 



The main cabin door on the wheelhouse side which is breached, however after a few minutes of sanding with a bit course sandpaper and a bit of elbow grease as come up well.  Now a lot more of this to come.



A small start, however, it is a good start and you can see the difference straight away. 



 

Comments

Post a Comment

Popular posts from this blog

Cleaning up the portside propeller Shaft & the propeller to find out the diameter and pitch & the manufacturer of the propeller

Image
Chance like a lot of James Silver / John Bain designed boats at the time Chance was build, they were twin screw single rudder designed.  The stern gear glands were of white metal and were very close fitting glands The original propellers that were fitted when Chance was originally launched in 1948 The original manufacturer of the propeller can be seen as Thornycroft   On this photo is can be seen that the diameter is 17 1/2 " x 12 1/2" These propeller shafts will have to be removed as there is work to be done on the stern tubes and the bearing changed to modern stern gear when Chance is re-engineered   
Read more

Engine filters from 70 years ago, all the parts can be washed and refitted non disposable parts, so no land fill

Image
The good part about the old fuel filter system on Chance is that it is a non disposable system, so it just needs cleaning at regular intervals to keep it working  Although there are a number of parts to the filter system it is straightforward and easy to dismantle and rebuild when it needs cleaning to maintain the engines   Just need a couple of parts replacing as they are worn out, apart from that the system is ready to be reused again for another 70 years or more   
Read more

What to say in videos which interest people to watch my video's

Show less Over the past three or so years, We as a family have tried to document the restoration of Chance. The restoration project as taken a long time as it as been done during the Covid 19 pandemic and the fact Chance was in a different part of the country to where we live, in Woodplumpton in Lancashire and we live in North East Essex, so the trips to Chance for the first two years of her restoration have been a long distance affair to say the least. However, we were up to it and we did a lot of work removing much of the old furniture and the other items from inside Chance which were beyond saving, such as rusted fuel and water tanks, worn out stern gear, Seized engines which could not be restored without a lot of money being spend on them. The inside of Chance was photographed a lot so to keep a record of how much of the interior was intact and what had been changed over the years and not always for the better and in some case caused major problem to the hull structure. this was fo...
Read more